![background image](http://html.mh-extra.com/html/royal/rg1000/rg1000_owners-manual_1493981025.webp)
Unexpected Temperature Displayed
Auger idle fuel feed rate is too high. Adjust smoke control switch (increase the “P” setting) to decrease idle fuel
feed rate.
Auger idle fuel feed rate is too low
Adjust smoke control switch (decrease the “P” setting) to increase idle fuel feed rate.
Grill lid is open
Close grill lid. Grill is designed to operate with grill lid closed.
Probe is defective
Control is defective
Contact Royall Grills technical support.
Contact Royall Grills technical support.
Grill Temperature Displayed is Diff erent Than Dome Thermometer
This is normal. The displayed temperature is the precise temperature at the Probe. The dome thermometer is located
in a diff erent position inside the grill.
Displayed Temperature is Flashing
Low grill temperature. This is not an error condition and does not aff ect the operation of the grill. The fl ashing display
is designed to alert the operator that there is some risk of the fi re going out.
Display Always Reads 0 Degrees
Probe wire leads are shorted. Check connection at control terminal J1. Fully open contacts by turning set screw
counter clockwise. Reinsert wires and tighten contacts by turning set screw clockwise. Check the insulation for
shorts throughout the wire run from detector to control terminal J1.
Probe is defective
Control is defective
Contact Royall Grills technical support.
Contact Royall Grills technical support.
Display is Flashing “ErP”
Inadvertent start error. The grill was plugged in with the cook control switch in the smoke position or set to a tem-
perature setting. Set the cook control switch to the off position.
Display is Flashing “ErH”
Overtemperature error. The grill temperature exceeded 615 degrees and shut off automatically. Set the cook control
switch to the off position.
Probe wire leads are open
Check connection at control terminal J1. Fully open contacts by turning set screw counter clockwise. Reinsert wires
and tighten contacts by turning set screw clockwise. Check for breaks in the wire throughout the wire run from probe
to control terminal J1.
Probe is defective
Control is defective
Contact Royall Grills technical support.
Contact Royall Grills technical support.