1. Fill tub with water from a garden hose.
2. Turn the thermostat
OFF
- at Equipment System inside the cabinet. “Off” is achieved
by turning the thermostat knob counter clockwise until it stops.
3. Turn power on by plugging the unit into the wall outlet and pressing the “Reset”
button located on the plug.
4. Be sure the Hi-Limit Switch is pushed
IN
on Equipment System. It is a small black
button located on the face of the control box inside the cabinet.
5. Check to be sure the Circulating Pump is operating (water flowing from small jets in
foot-well). One jet may be the Ozonator Jet and not appear to be working. You can
also check the clear tube coming out of the small Circulating Pump, (at Equipment
System inside of the cabinet) and going into the Heater Housing, to see if the water is
flowing properly.
6. Allow the jets to run for 2-3 minutes with the heat still in the
OFF
position.
7. Check to be sure there are no air locks.
(
WARNING
Air locks can cause
instantaneous heater failure, known as “dry-firing”, and this is
not
covered
under warranty)
8. Check for water leaks at Couplers on the heater housing and hand tighten
if necessary.
9. Turn temperature on the Equipment System to desired level. Periodically check
temperature of water to until desired temperature is reached. Reduce thermostat
setting until heater turns off. Keep the cover on the unit to ensure the water heats
properly. Not having the cover on the unit may prevent the unit from heating up.
10. Check Alkalinity and PH with test strips or test kit and adjust accordingly.
11. Add initial chemicals according to the “Portable Baptistry Chemistry”
section of this manual.
12. Do Timely Maintenance as directed, and
ENJOY YOUR BAPTISTRY!
13. Contact your local Royal Spa Representative to answer any questions that you
may have.
INITIAL START UP
Содержание PORTABLE BAPTISTRY
Страница 9: ...Portable Baptistry Draining...
