12
1. Turn on the power switch located on the rear of the machine.
2. Set the pressure lever to the "Laminating mode".
3. Adjust the roller temperature in accordance with the film type and thickness. If you
already have a setting in the memory that you want to use press the
button and
then the
or
buttons to select your desired setting.
4. When the desired temperature is met "READY" will be displayed on the screen and you
will hear a beep.
5. Press the
button. The rollers should begin to turn, if they do not turn make sure the
safety cover is closed or check the troubleshooting section of the manual.
6. Use the upper and lower Tension knobs to properly adjust the tension of the roll film.
Having the tension too tight will slow down or prevent the rollers from turning and if the
tension is set too low this can cause wrinkles in your lamination.
7. For ease and convenience set the document guides in position.
8. Set document on the table.
9. Press the
button when lamination is competed.
10. When lamination is completed your item may be hot and can easily bend. Lay on a flat
surface to properly cool.
11. When you have completed all of your lamination, set the pressure lever to the OPEN
position.
12. Turn the Power switch off.
9.1. hOT LAmINATING
9. LAmINATING STEPS
