RSC-LS/LSH/CW/HW SERIES
13
Installation of the Front Feeder Option (Includes 2 brackets,
one spindle, and mounting hardware).
1. Install the Front Feeder to the inside of the front frames using
four 1/4" (M6) hexagon bolts on each side (Figure 1).
Installing the Rear Rewinder Option (Includes motorized
winder, bracket, one spindle, and mounting hardware).
1. Remove the left and right covers by using a screwdriver
(four screws on each side cover) (Figure 2 & 3).
2. Remove the lever knob screw and lever (Figure 4).
3. Disassemble the power switch bracket and place the left
rewinder outside of the frame; fasten with round head
3/16"(M5) screws (included in the option kit). Then, reinstall
the power switch bracket (Figure 5).
4. Install the right rewinder on the outside of the frame and
connect the motor wire connector to the rear wire
(Figure 6 & 7).
5. Reinstall the rear cover.
6. Reinstall the side covers.
7. Reinstall the lever knob and screw.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
12. INSTALLATION OF FRONT FEEDER and REAR REWINDER
OPTIONS
NOTE:
Below options are to be installed by an authorized RS
reseller.
