10
11. THREADING FILM
Figure 1
Figure 2
11.1. Decaling
1. Turn the power switch on (“I” position). The Power
switch is located on the rear left side of the unit.
2. Complete the steps as in the “LOADING FILM”
section (see page 10).
3. Set the top roller to the desired temperature .
4. Take off the Frame-Paper Guide and the Feed Table.
5. Pull the top film down over the Safety Cover to the
bottom of the craft paper/mounting film.
6. Align and center the craft paper/mounting film to the
top film and tighten the two lower core screws (Figure
1).
7. Thread the top film underneath the Upper Idle Bar.
(Figure 2)
8. Tape the top film on to the Release Liner Take-Up.
(Figure 2)
TAKE UP DEVICE
PAPER BACK
HOT ROLLER
BACKING PAPER
BASE FILM
LOEWER IDLE BAR
UPPER IDLE BAR
COLD FILM
