Royal Range of California BPQ-30, Руководство пользователя

Страница: 12 / 15

12
Front panel removal
- Pull knobs out.
- Remove screws (4).
- Pull panel out slightly.
- Disconnect wires from
module and switch.
- Replace in reverse orde
r.
Parts Removal and Replacement
Grill Burner: Remove top grates. Remove shields. Unscrew the burner at rear and
slide out. Clean and replace in reverse order.
Grill Sparker:
Remove top grates and shields. Unscrew the sparker bracket from inside.
Disconnect wire. Replace in the reverse order.
Electronic Module:
Unscrew the module cap from front. Unscrew the holding nut from front.
Remove the module from the rear after disconnecting the wires from the
module. Replace in reverse order.
Battery:
Unscrew the module cap from front. Remove battery.
Replace new battery and screw cap on.
Rotisserie Sparker:
Remove sparker cover – lift and pull. Remove sparker screws and pull
out. Disconnect wire at rear. Replace in reverse order.
Switch:
Remove front panel. Disconnect wire from switch at rear.
Press and push switch from rear of the panel. Replace in reverse order.
Trouble Shooting
Problem Solution
Burner will not light Check gas supply to burner by manually lighting the burners.
See electrode for visible damage, if damaged replace.
If loose wire at igniter or electrode, push in tightly.
Check battery, replace if necessary.
Improper burner flame
Check burner gas inlet area for any blockage and clear.
Check orifice hoods for any clogging and clean. Adjust air shutter,
if necessary. Check pressure if flame is too low or too high.
Check gas supply tank (LP) if running low.
Light is not ON
Connect 115V power at rear. Turn switch ON.
Check bulb. Replace if necessary.