Modules installation
Remove any dirt inside the frame.
Lubricate the inside surfaces of
the frame with Roxtec Lubricant,
especially into the corners.
Adapt modules which are to hold
cables or pipes by peeling layers until
you reach the gap seen in pic. 3.
Achieve a 0.1-1.0 mm gap between
the two halves when held against
the cable/pipe.
Lubricate all modules for the frame
thoroughly, both the inside and the
outside surfaces.
Insert the modules according to
your installation plan (transit plan).
Usually start with the largest
modules.
Insert a stayplate on top of the
finished row of modules.
Before inserting the final row of
modules, insert two stayplates.
Separate the two stayplates and
insert the final row of modules
between the stayplates.
Drop the upper stayplate on top of
the modules.
Lubricate all sides of the wedge
sparsely, except front and back.
Please read the markings on the
wedge and turn it correctly before
inserting it in the top of the frame
(standard position). Face with
“Stayplate this side” must always
face a stayplate.
Tighten the screws until full stop,
approx. 20 Nm (15 ft.lb.).
Attach the Wedge Clip to the wedge
bolts to check that the wedge has
been properly tightened.
Optional wedge positions
(anywhere within the frame).
Stayplate Clips (D) and Stayplate
Clamps (E) can be used to simplify
horizontal assembly.
