INSTALLATION MANUAL
GRAND BOX
CABLE INSTALLATION
2. Connect the electrical cables as
shown in the figure.
NOTE: Electrical connection process is
an operation on the electrical
system of the vehicle. So,
vehicle may be out off warranty
after this process.
REMOTE CONTROLLER
1. Push the button on the module 8
times. The lamp next to the button
will flash.
2. Push the button once again. The
lamp will light up permanently.
3. Push any button on the remote
controller to finish the calibration
procedure.
CABLE INSTALLATION
1. Take the supply voltage directly
from the main battery.
NOTE: Electrical operations must be
performed by a skilled operator
or in a autorized service.
Roxform DOES NOT take any
responsibilities for any damage
which result from electrical
operations.
CONTROLS
1. Check all illumination functions after installation.
2. Check remote controller functions after installation.
3. Check the sealings to spill water on the cap slowly. DO NOT use high-pressure water to check leakage.
4. Check mounting hardware monthly for tightness. Cap clamps are suitable for securing caps when properly used.
INSTALLATION
