Roxell CoMeo, Инструкция по использованию и сборке

Страница: 13 / 122

ROXELL - 001 - 2415
COMEO - INSTRUCTIONS FOR THE USER
I- 5
USING THE SYSTEM FOR OLDER BIRDS
Suspend the lines at the correct height. You will obtain
optimum results when the birds can easily pick the feed
from the deepest part of the pan.
If birds necks rest on the edge of the pan, the feeder
line is adjusted too high.
On the contrary, if birds perch on the edge of the pan,
the line is adjusted too low.
You will prevent feed waste by keeping the pans at the
correct height !
The correct position of the feed level ring will be found
by experience.
You must consider feed composition, fat content and
type of birds.
Optimum feeding results will be obtained with
adequate pan height, correct adjustment of the feed
level ring.
The 100kg. hopper should be filled before starting the
lines. So the transport system has a head start to
supply the hoppers.
AT THE END OF A FLOCK
Have all pans emptied at the end of the flock. Also
ensure that all feed is removed from the tubes.
Winch up the complete installation to remove birds and
manure.
NEVER STAY UNDERNEATH
WHEN LOWERING OR WINCHING
UP THE FEEDER LINES. STOP
IMMEDIATELY
AT THE
SLIGHTEST HITCH.
DANGER
Take care not to damage the pans (with heavy objects
or machines) when cleaning out the house.
CLEANING
To clean the installation winch up the feeder lines to a
working height of about 1m.
Remove possible feed residues by turning the pans a
couple of times 180 degrees around the tubes or by
removing the pans from the 12 fin support.
You can now easily clean the rotating pans one after
another by means of a high pressure cleaner.
To put back the pan : take it in one hand (like a dish) and
push it into the 12 fin support from below.
With the other hand, hold the feed level ring so that the
12 fin support cannot go up.
ONLY FOR COMEO WITH CLEANING OPTION :
Follow the steps below when using the cleaning option.
- Open the cone by pulling on both handles
FIGURE 1.
- Clean the Comeo by using heigh pressure
water on the inside of the cone and clean from
top to bottom.
FIGURE 2.
FIGURE 3.
- For closing the cone : turn the feeder 180
degrees around the feeding tube. Important to
hear 2 clicks.
FIGURE 4. FIGURE 5.
DON'T FORGET TO COVER UP THE CONTROL
PAN WITH PLASTIC !
Motors and switches are IP55. This means that they
resist splashing, NOT jets from a high pressure
cleaner.
After cleaning, tip the water out of the pans.
Take care that no water remains in the feed intake boot
(corrosion !!!) You can avoid this :
- by loosening the tube clamp and turning the feed
intake boot with the opening downwards before you
use the high pressure cleaner, or
- by hanging up the feed intake boot, so that all
remaining water flows away through the hole in the
tube. This method requires an extra suspension
point next to the 100kg hopper or fixing the hopper
suspension chain to the feed intake boot.
The pan, made of high quality polypropylene, resists
practically all cleansers and disinfectants.
If you want to use an aggressive product (**) first
contact your supplier !!
Hang the
OPERATION INSTRUCTIONS
at a spot
inside the house where it catches the eye.