Cross section of wall
angled edge
Angled end of felt batten
Front face
Felt batten
Front face of the felt
batten is level with
the edge of the roof.
14. Felt battens
Around the edge of the roof position the angled edges of the felt batten against the underside of the roof panel, have the front face of the batten level with the end of the
roof panel as shown. Secure in place using 4 x 25mm screws for the Long felt battens and 3 x 25mm screws for the short battens.
Short felt
batten
Short felt
batten
Metal handle bar
12mm
Drill
13. Doors
Fit four hinges to the long rebated edges of each door. Evenly space the hinges along the length of the doors leaving 150mm from the top and bottom of the door. Attach
the small tab of each hinge using 2 x 25mm screws. Open the hinges and fit them around the door frame, adjust the door to the correct height and fix the hinges to the
door frame using 3 x 25mm screws per hinge. Attach the tower bolts to the inside of the left door using 4 x 19mm roundhead screws per bolt. With the left door shut,
mark where the bolts touch the floor and door header rail and Drill a 12mm hole for each bolt to fit in. To fit the door handle. Push the door lock into the rebate on the
edge of the right-hand door and secure using 2 x 25mm brass screws. Push the metal handle bar through the door latch mechanism. Fit a door handle to the metal handle
bar on each side of the door and secure each handle in place using 4 x 25mm black screws. On the other door fit the lock catch plate using 2 x 25mm brass screws.
25mm
25mm
19mm
25mm
25mm
25mm
25mm
