10. Roof coverstrips
Under the flap of roof felt that overlaps the glazed panels, add a good bead of silicon. Drill four pilot holes evenly spaced along the length of each roof felt to glazed panel
coverstrips. Align over the join of the solid roof panel and glazed panel, tuck under the roof capping and secure using 4 x 25mm screws. Drill four pilot holes evenly spaced
along the length of each angled roof coverstrip. Apply a good bead of silicon along the underside of the strips. Position a strip over each of the roof panel joins, tucking each
one under the top cap with the pointed end pointing down the roof, Secure each strip with 4 x 25mm screws.
11. Corner/joint coverstrips
Secure the seven corner/joint coverstrip and the four angled corner coverstrips in the positions shown in the second diagram. Each strip is fixed using 4 x 30mm nails evenly
spaced along the length of the strip
22mm
50mm
It will be necessary to
drill holes for the 4
coach bolts using a 6mm
diameter drill bit.
Drill
25mm
30mm
30mm
25mm
Important note
Ensure a good bead of silicon
has been applied under the flap
of roof felt that overlaps the
glazed panels before screwing
the coverstrips down.
Flap of roof felt overlapping
glazed panels
Flap of roof felt overlapping
glazed panels
25mm
It is recommended to drill pilot holes with a
3mm drill bit for all screws in this section.
3mm
Drill
25mm
Important note
Add a bead of silicon sealant to the
underside of each strip just prior to
positioning them and fixing them down.
Corner/joint coverstrips
Angled coverstrips
Angled coverstrips
Corner/joint coverstrips
Corner/joint
coverstrips
32mm
35mm
12. Door
Attach the door rebate strips flush to the framing of the door opening using 5 x 35mm nails per strip.
Position the door in the opening and secure in place with 3 T-
hinges and 7 x 32mm screws per hinge. Fit the pad bolt to the door using 4 x 22mm screws and 2 x 50mm coach bolts, nuts and washers. It will be necessary to drill holes
for the coach bolts using a 6mm diameter drill bit. Fit the catch plate to the wall panel ensure the bolt is able to slide into the catch plate. Attach using 2 x 22mm screws and
2 x 50mm coach bolts, nuts and washers. Position the turn button near the top of the door, secure to the wall panel using 1 x 25mm screw.
