Drill pilot holes with a 3mm drill bit for all
screws in this section.
side wall panel
back wall panel (570mm)
50mm
Panel frames
rest on floor.
Panel cladding
overhangs floor
edge.
2. Wall panels
Position the 570mm wide wall panel and a large wall panel on the floor as shown. Note how the panel frames sit on the floor with the panel cladding overhanging the floor
edge. Ensure square and secure using 4 x 50mm screws, screw through the frame of the small panel into the frame of the large panel. Position a 526mm wide wall panel
next to the large panel, ensure square and secure them together in the same way. Continue adding the rest of the panels as shown in the diagrams using 4 x 50mm screws
per join. Lift the apex panel on top of the back wall, make sure the bottom shiplap board of the apex panel fits correctly into the top shiplap board of the back panel. Secure
by using 4 x 50mm screws, screw up through the top frame of the back panel into the bottom frame of the apex panel.
Important note
To "
VALIDATE
" the guarantee, adequate provision must
be made to ensure ground contact is avoided and air is
able to circulate underneath the building.
Placing the building on a concrete pad or slab base is
acceptable provided that the building is not allowed to sit
in pooled water during wet conditions.
If the building is to sit on soil or grass it
MUST
be
erected on pressure treated wooden 50mm x 50mm or
similar bearers
(These are not supplied in the kit).
Rowlinson Garden Products recommend using pressure
treated bearers with all buildings on any type of base.
3. Secure the walls to the floor
Ensure the panels are sitting square on the floor. Secure using 19 x 63mm screws, screw through the panel frames and floor into the floor joists.
63mm
1. Floor panels
Prepare a level area for the shed to sit. Position the three floor panels together and check that the whole floor is sitting level.
570mm
Drill pilot holes with a 3mm drill bit for all
screws in this section.
3mm
Drill
50mm
Floor
50mm
Use this diagram to check the
correct orientation of the corners
Important
Ensure the back
panel and apex
panel interlock
correctly.
Apex panel
Back panel
63mm
3mm
Drill
526mm
side wall
Back wall
Door panel
