33/40
4.
Cleaning and Maintenance
4.1 Safety measures
P
Always pull the mains plug out of the socket before servicing the appliance.
P
Only begin the maintenance or repair work once the Infrared patio heater has cooled
down.
4.2 Cleaning
The patio heater should be covered after each use to prevent contamination by impurities.
Do not cover the appliance until it has fully cooled down.
It is necessary to clean the appliance form time to time, depending on the location. Observe
the following information during cleaning:
P
Only clean the patio heater when cooled down.
P
Pull out the power plug before any work.
P
Only clean the patio heater with a dry, soft cloth. Never use sharp and/or abrasive
cleaning agents.
4.3 Troubleshooting
Fault
Possible
cause(s)
Remedy
Tab. 3: Error diagnosis
Appliance does
not start.
The appliance
is connected to
a socket, but the
heating tube
does not light up.
No power or voltage too
low.
The thermostat is set too
low
The appliance is not
switched on.
The thermostat is set too
low
The heating tube is defec-
tive.
Make sure the plug is plugged into the
socket. Check the power supply voltage.
Set the thermostat to a higher temperature.
Check the setting
at the thermostat rotary knob and, if neces-
sary, turn this to switch on the appliance.
Set the thermostat to a higher temperature.
Check the heating tube and replace this, if
necessary. Our Service will be pleased to
help you.
EN
FIN_103030102_DE-GB_HIT 2000-1 W Basic.indd 33
10.06.2014 10:12:49
