9
FOR YOUR INFORMATION (
▲
):
(
▲
) On electronic models, the control lever can only be locked in the lower position when the toaster is plugged in.
(
▲
) Any bread extending beyond the toaster slots will not be toasted.
(
▲
) Do not force the control lever as you may damage the mechanism.
(
▲
) When toasting currant buns or teacakes, remove any loose currants from the bread before placing them in the
toaster. Loose currants may fall into the appliance and damage the toaster.
(
▲
) Do not use any abrasive cleaning agents (no soda-based scouring products, no scouring pads...), no metallic
utensils, metal scouring pads etc.
(
▲
) Use just a soft cloth or a slightly damp sponge with a little washing up liquid.
(
▲
) The packaging box may be recycled, but it may be useful for returning the appliance to an authorised Service
Dealer if necessary.
WARNING: THIS APPLIANCE MUST BE EARTHED. FOR UK ONLY
Important: the wires in this lead are coloured in accordance with the following codes:
Green and Yellow: Earth
Blue: Neutral
Brown: Live
Connect the Green/Yellow wire to the terminal in the plug marked “E” (or by the
earth symbol) or coloured Green or coloured Green and Yellow. Connect the Brown
wire to the terminal in the plug marked “L” or coloured Red. Connect the Blue wire
to the terminal in the plug marked “N” or coloured Black. A 13 amp fuse should be
fitted when the appliance is connected to a BS 1363 plug. Seek professional advice
if you are unsure of the correct procedure for the above.
VOLTAGE
This appliance is designed to run on 230 - 240 volts only. Check that the mains supply corresponds to that shown on
the rating plate of the appliance. If the appliance is to be used in any country other than that of purchase, it should be
checked by an approved Service Dealer. Standards can vary from country to country.
* depending on model
Select the desired browning control setting. The browning
control dial on the toaster shows a specific picture
.
Lower the control lever once until it locks in the low posi-
tion.
The toaster is now on, and heat is rising through the
warming plate to evenly heat breads rolls on top.
The toaster stops automatically and the control lever
springs up.
To reheat the other side, turn the bakery products over
using oven gloves or bread tongs if necessary as the
metal croissant warmer may still be hot
▲
- Fig.
(Bread tongs not provided with the toaster)
For an optimum result, press the lever control down
a second time and then press on the “ PLUS “
button
,the heat rises through the warming plate
and does not toast the bakery product being warmed
- Fig.
The bakery product(s) can be left on the warming plate
for a few minutes and they will remain warm.
MAINTENANCE, CLEANING AND PUTTING AWAY
▲
Always unplug the toaster and let it cool before any
cleaning or handling.
Wipe the outside of the toaster , the cord and the war-
ming plate with a damp cloth or a slightly damp sponge
with a little washing up liquid. Dry thoroughly
- Fig.
For appliance with a metallic finish:
Do not use any cleaning products designed for metals ;
use a soft cloth with a window or glass cleaner.
For removal of the Integrated warming plate*
Grip the metal warming plate by the middle and gently
pull until it becomes detached. Clean with washing up
liquid, then dry thoroughly - Fig.
-
For replacing the warming plate on the top, insert the 4
small tongues in the .metal support in the corresponding
slots on the toaster and check that it is correctly in place
before each use
▲
- Fig.
To clean the crumb tray
Pull out the tray completely. Remove the crumbs -
▲
Fig.
Wipe it clean.
Do this regularly, after each use if possible (toasting or
re-heating).
If crumbs or crusts remain inside the heating elements,
remove the warming plate* and turn the toaster upside
down, so that these remaining crumbs fall out.
Replace the crumb tray and the metal warming plate
carefully.
Wind the cord around the cord storage area under the
toaster - Fig.
15
11
14
13
12
10
5
plus
9
3303219 VENUS FAAHIEPGT 7/02/02 16:29 Page 9
