11
4 • Set the vacuum power
(fig. 9)
Max: Floors
Min: Furniture, delicate fabrics…
5 • Switch off your vacuum cleaner
(fig. 10)
STORAGE
(fig. 11)
CLEANING AND MAINTENANCE
The air we breathe contains particles, which may cause allergies; the larvae and waste of mites,
moulds, pollen, smoke and animal residues (hair, skin, saliva, urine). The finest particles penetrate into
the respirator where they may cause inflammation and completely alter the respiratory function.
HEPA filters (high efficiency particulate air filters, namely high efficiency filters for air-borne particle fil-
ters) make it possible to hold back the finest particles. Thanks to the HEPA filter, spent air in the room
is cleaner than vacuumed air.
IMPORTANT
Always switch off and disconnect your vacuum cleaner before servicing or cleaning. Check and clean
regularly your whole vacuum cleaner and the different filters.
ATTENTION
Never use your vacuum cleaner without the filtration system (microfilter and filter).
1 • Cleaning the dust container (5)
Quick emptying
When the dust container (5) is full, remove the cover from the vacuum cleaner
(Fig. 12)
then remove
the dust container (5) by sliding it slightly downwards
(Fig. 13)
. Place it over a waste container and
press the button marked "Push" to tip the emptying flap down, then empty out the contents of the
container
(Fig. 14)
. Close up the flap
(Fig. 15)
and refit the dust container, then refit the cover onto
the vacuum cleaner
(Fig. 16)
.
Complete cleaning
The container assembly (5) requires regular cleaning.
Remove the cover from the vacuum cleaner
(Fig. 12)
. Then remove the dust container (5) by sliding
it slightly downwards
(Fig. 13)
. Then separate each element: Remove the dust container cap (5c) then
the HEPA filter (5b3).
Then remove the foam filter (5b2) and the separator (5b1).
Place the receptacle/dust container (5a) and separator (5b1) under warm water, then leave it to dry or
wipe it with a dry cloth
(Fig. 17)
.
For cleaning the foam filter (5b2) : Please refer to Section 2 – CLEANING THE FOAM FILTER. For clea-
ning the HEPA filter (5b3) : For information on servicing filters, please refer to Section 3 – CLEANING
THE HEPA FILTER.
Once dry, refit the dust container (5) elements, then refit the complete assembly onto the vacuum
cleaner
(Fig. 16)
.
Refit the vacuum cleaner cover (7).
2 • Cleaning the foam filter (5b2)
The foam filter (5b2) should be cleaned after every use, using warm soapy water
(Fig. 18)
. Rinse and
leave to dry for at least 12 hours before refitting.
An additional foam filter is supplied with your vacuum cleaner so that you can continue to use your
vacuum cleaner while the original foam filter is drying.
* Depending on model
EN
RO_POWERLINE-CYCLONIC_RH79_903525-03.qxp_903525/03 04/08/2015 11:28 Page11
