Rowenta POWERLINE CYCLONIC RH7755IA, Руководство пользователя

Страница: 15 / 28

11
HEPA filters (high efficiency particulate air filters, namely high efficiency filters for air-borne par-
ticle filters) make it possible to hold back the finest particles. Thanks to the HEPA filter, spent air
in the room is cleaner than vacuumed air.
IMPORTANT
Always switch off and disconnect your vacuum cleaner before servicing or cleaning. Check and clean
regularly your whole vacuum cleaner and the different filters.
ATTENTION
Never use your vacuum cleaner without the filtration system (microfilter and filter).
1 • Cleaning the dust container (5)
Quick emptying
When the dust container (5) is full, remove the cover from the vacuum cleaner
(Fig. 12)
then remove
the dust container (5) by sliding it slightly downwards
(Fig. 13)
. Place it over a waste container and
press the button marked "Push" to tip the emptying flap down, then empty out the contents of the
container
(Fig. 14)
. Close up the flap
(Fig. 15)
and refit the dust container, then refit the cover onto
the vacuum cleaner
(Fig. 16)
.
Complete cleaning
The container assembly (5) requires regular cleaning.
Remove the cover from the vacuum cleaner
(Fig. 12)
. Then remove the dust container (5) by sliding
it slightly downwards
(Fig. 13)
. Then separate each element: Remove the dust container cap (5c)
then the HEPA filter (5b3).
Then remove the foam filter (5b2) and the separator (5b1).
Place the receptacle/dust container (5a) and separator (5b1) under warm water, then leave it to dry or
wipe it with a dry cloth
(Fig. 17)
.
For cleaning the foam filter (5b2) : Please refer to Section 2 – CLEANING THE FOAM FILTER. For clea-
ning the HEPA filter (5b3) : For information on servicing filters, please refer to Section 3 – CLEANING
THE HEPA FILTER.
Once dry, refit the dust container (5) elements, then refit the complete assembly onto the vacuum
cleaner
(Fig. 16)
.
Refit the vacuum cleaner cover (7).
2 • Cleaning the foam filter (5b2)
The foam filter (5b2) should be cleaned after every use, using warm soapy water
(Fig. 18)
. Rinse and
leave to dry for at least 12 hours before refitting.
An additional foam filter is supplied with your vacuum cleaner so that you can continue to use your
vacuum cleaner while the original foam filter is drying.
3 • Cleaning the HEPA filter
Your vacuum cleaner is fitted with a HEPA filter (5b3).
If you notice your vacuum cleaner losing power, then we recommend that you clean the HEPA filter to
retain vacuum performance:
- remove the cover from the vacuum cleaner
(Fig. 12)
- remove the dust container by sliding it slightly downwards
(Fig. 13)
then remove the dust contai-
ner cap (5c)
- pull out the HEPA
(Fig. 19-20-21)
filter and tap it lightly over a waste container
(Fig. 22)
Replace the HEPA filter inside the dust container cap, refit the dust container elements, then refit the
complete assembly onto the vacuum cleaner. Refit the vacuum cleaner cover (7).
* Depending on model
EN