Rowenta Expertise, Инструкция по эксплуатации

Страница: 9 / 82

12 • PUTTING YOUR STEAM GENERATOR AWAY
1. Press the illuminated on/off switch O/I and unplug the generator.
2. Place the iron on the iron rest plate.
3. Press the cord reel button and guide the cord with your hand (20)
4. Leave the iron (and the iron rest) to cool down for 30 minutes.
5. You can now put your steam generator away.
GB
Before attempting to rinse the boiler of your generator, it is essential to leave it to cool for
at least 2 hours in order to avoid any risk of scalding.
If the orange “boiler rinse” light flashes, you can continue ironing normally
but remember to rinse the boiler first, the next time that you use it.
1. Check that the generator is cold and unplugged.
2. Place your steam generator on the edge of your sink.
3. Remove the boiler rinsing cover located on the side of the appliance.
4. Using a coin, gently unscrew the boiler rinse plug.
5. Holding your steam generator in a tilted position, and using a jug, fill the boiler (in the base unit)
with 1/4 litre of tap water.
6. Shake the base unit for a few moments and then empty it completely over your sink.
To obtain the best result, we recommend that this operation is done twice.
7. Screw back and tighten up the boiler rinse plug with a coin.
8. Put the boiler rinsing cover back in place.
9. The next time you use the generator, hold down the “restart” button
for 2 to 3 seconds to turn off the orange light.
II - TO RINSE THE BOILER WITHOUT THE RINSING ACCESSORY
(20)
1800113332 GRB DG9020 30 40:1800113332 GRB DG9020 30 40 14/03/08 9:04 Page 10