Rowenta EP4760, Инструкция по эксплуатации

Страница: 14 / 101

MAINTENANCE AND CLEANING
- If you want a hair length of
approximately 9 mm, use the largest
comb.
- If you want a hair length of
approximately 3 mm, use the smallest
comb.
- If you want a hair length of
approximately 6 mm, use the medium-
sized comb.
Slide the comb into the two grooves on
the trimmer head
(fig.12) , then set the
switch to 1 .
Hold the appliance upright so that you
can see the appliance name, and move
it slowly against the hair
(fig.13) .
IMPORTANT
If your skin becomes irritated, apply
some talc after use.
If you want a closer shave, use the
bikini line trimmer head without the
comb:
Set the switch to
0 and plug in the
appliance.
Push to remove the comb
(fig.14) .
Next, switch the appliance on using the
on/off switch.
Hold the appliance upright and move it
slowly against the hair (fig.15) .
6 • For a neat bikini outline
IMPORTANT
For greater effectiveness, pull hair
outward with the other hand to
make it stand out. This will give you
a more precise shave with little
irritation.
7 • Cleaning the epilator head
Stop the appliance and unplug it.
Press the release button on the head
and remove the epilator head
(fig.16) .
Rinse the epilator head under cold run-
ning water by turning it for 5 to 10
seconds
(fig.18) .
Shake the epilator head vigorously
(fig.19) and dry it with a towel before
fitting it to the epilator again.
IMPORTANT
You can also use the small cleaning
brush supplied (fig.17).
8 • Cleaning the sensitive area accessory
Clean the accessory with alcohol and rinse it under running water (fig.20) .
GB
NOT EP4760F4 032052 22/03/07 10:55 Page 15