Rover XT133, Руководство оператора

Страница: 8 / 22

INSTALL AND ADJUST THE U-HANDLE
2. You can adjust the operating angles of the
handle by loosening the handle locking knob.
Align the two holes on the cutting attachment
shield with the other two holes in the clamping
bracket, and then use the two screws to connect
them together.
1. Put the U-handle between the top and
middle clamps, and then connect the top,
middle and bottom clamps by tightening
the handle locking knob.
- 8 -
Cutting
Attachment
Shield
Clamping
Bracket
ASSEMBLY INSTRUCTIONS
INSTALL THE CUTTING ATTACHMENT SHIELD
Handle
Locking
Knob
Top Clamp
INSTALL THE TRIMMER HEAD
1. Align the shaft bushing hole with the locking
rod slot in the protective cover and the
notch in the gear case, and then insert the
locking rod into these three holes/slots.
Holding the locking rod to ensure the output
shaft in place.
2. Ensure the threads of the trimmer head and
the center of the output shaft are in line
with each other, and then rotate the trimmer
head anticlockwise until it is securely
tightened.
Shaft Bushing
Protective Cover
INSTALL THE CUTTING BLADE
1. Align the shaft bushing hole with the locking
rod slot in the protective cover and the notch
in the gear case, and then insert the locking
rod into these three holes/slots. Holding the
locking rod to ensure the output shaft in
place.
2. Install the blade to the output shaft and
make sure it contacts closely with the shaft
busing.
Shaft Tube
Middle Clamp
Output Shaft
Bottom Clamp