OUTLINE S.R.L.
Via Leonardo da Vinci, 56
25020 Flero (Brescia) Italy
Tel.: +39 030.3581341
Fax +39 030.3580431
www.outline.it
4
RIGGING INSTRUCTIONS
This system offers two M6 threaded inserts, one
on each side, which allow to properly use rigging
bracket to hang the speaker.
Always place the washers between the cabinet
and the bracket, as shown in the figure.
The bracket has rails in correspondence with two
inserts to perfectly fit the cabinet in any case and a
M10 threaded insert for stand mounting.
ACCESSORIES
There are other three M4 threaded insert on the
rear panel to use other accessories, weatherproof
cable protection or safety cable attachments.
Please, note that screws longer than 25 mm
cannot be used for these inserts and they must
always be covered, when they are not used, to
protect the loudspeaker from dust or anything else.
A weatherproof cable protection plate (WPCON-04
- optional) is available to ensure the normal
operation also in extreme conditions.
To install the plate proceed as follows:
• Attach the neoprene gasket following the
outline of the cap. Beware to start and finish
on the bottom edge.
• Pass the wires through the cable glands
before installing the accessory.
• Fix the plate and secure the screw (no longer
than 25 mm) into the threaded insert in the
center of the rear panel as shown in the
picture.
