7
Display Cabinet vertiCal
P/N 1011068 Rev. D 08/10
figure 1. DcV-200 and crumb tray
Unpacking
1. Remove unit and all packing materials from
shipping carton.
2. Open the large box. Remove all packing materi-
als and protective coverings from the unit and
parts.
nOte: If any parts are missing, contact a.J
antunes & co. ImmeDIately at 1-877-392-7854 in
the U.s., or 630-784-1000 outside the U.s.
3. Wash the crumb tray (figure 1) in soap and
water. Wipe all surfaces of the unit with a hot
damp cloth.
nOte: Do nOt use a dripping wet cloth. wring out
before use.
4. allow crumb tray to dry.
equipment setup
When placing the unit into service, pay attention to the
following guidelines:
• Make sure power to the unit is off and the unit is
at room temperature.
• Do NOT block or cover any openings on the unit.
• Do NOT immerse cord or plug in water.
• Keep cord away from heated surfaces.
• Do NOT allow cord to hang over edge of table or
counter.
• Place unit on a sturdy, level table or work sur
-
face.
• Ensure that the line voltage corresponds to the
stated voltage on the unit specification label
located at the end of the power cord.
• Turn the power switch off before connecting the
unit to the power supply.
InstallatIOn
caUtIOn
all electrical connections must be in accordance
with local electrical codes and any other appli-
cable codes.
warnInG
be sure to follow all of the warnings and precau-
tions listed in the Important safety Information
section of this manual.
