Roundup 9210805, Руководство пользователя

Страница: 15 / 20

UNIVERSAL TOASTER UTX-200L
15 P/N 1010992 Rev. K 03/15
McDonald’s
DAILY: Cleaning the Accessories, Release
Sheet, and Vertical Conveyor Belt
NOTE: Do NOT wash accessories in the Power
Soak machine.
CLEANING THE ACCESSORIES AND TOASTER
1. Turn the Power Switch off. The red light on the
switch turns off (if present).
2. The unit enters cool down mode and displays
OK to Clean
. The fans continue to run. This
cool down mode continues for 45 minutes and
shuts the unit down automatically when complete.
NOTE: You do NOT need to wait for the count down
to complete. Continue with the cleaning steps as
soon as you see
OK to Clean
.
3. Wearing Heat Resistant Gloves, remove the
following items from the unit (refer to Figure 1):
• Breakfast Chute (Rear of unit)
• Bun Feeder (Top of unit)
• Bun Buffer (Front of unit)
• Unit Crumb Tray (Rear of unit)
• Release Sheet Retainer Bar and Release
Sheet (Top of unit)
MAINTENANCE
WARNING
The unit will remain hot to the touch while it is
cooling down. Personal injury and burns may
result from touching the unit before it is finished
cooling down. Wear Heat Resistant Gloves!
CLEANING THE RELEASE SHEET
1. Remove the Release Sheet from the Release
Sheet Retainer Bar and inspect both sides of the
Release sheet.
NOTE: Replace the Release Sheet if it is overly
worn, creased, or torn.
2. Lay the release sheet on a clean, flat, dry sur-
face. Spray EXCEED Glass and Multi-Purpose
Cleaner (HCS) on a clean, dry towel.
3. Wipe the Release Sheet firmly from top to bottom
over its entire surface.
4. Immediately repeat this procedure with a clean,
dry towel dampened with water.
5. Finally, wipe the entire Release Sheet with a clean
towel dampened with KAYQUAT II™ Sanitizer
Solution (HCS) and allow to air dry.
6. Turn the Release Sheet over and repeat Steps 2
through 5 on the reverse side.
CLEANING THE VERTICAL CONVEYOR BELT
NOTE: Wear Heat Resistant Neoprene Gloves.
1. Face the rear of the unit. Turn the two Back Panel
Release Latches (Figure 8) to the vertical position
and open the Back Panel.
WARNING
Do NOT wash any of the accessories in a Power
Soak Machine or any other mechanical washer.
Damage to the accessories may result. Wash all
accessories by hand in the sink.
4. Set the Release Sheet Retainer Bar and the
Release Sheet aside.
5. Wash the Breakfast Chute, Bun Feeder, Bun
Buffer, and Crumb Tray in the three compartment
sink.
6. Wipe down the outside of the toaster with a clean,
sanitized towel dampened with KAYQUAT II™
Sanitizer Solution (HCS) .
WARNING
The Horizontal Conveyor Belt and the Vertical
Conveyor Belt continue to turn during Cleaning
mode. To stop the belts, press the UT button. To
temporarily advance the belts during cleaning,
press and hold both MUFFIN/BAGEL buttons as
desired. Release to stop the belts again. Be sure
to press UT again to resume.