raised so, insert the end of the plastic pipe into the boiler and
withdraw 30 ml of water with the syringe. Replace the filler plug
finger tight, and then place the dome back over it. Note that there is
a rubber ‘O’ ring around the body of each filler plug. This is to retain
the domes during normal operation.
2/ Pump bottle when hot or cold.
In the Right Hand side of the cab is a top-up-valve. Fill the plastic
pump bottle with clean water and push the end of the plastic tube
into the socket in the top up valve.
The socket has a slight taper in it, and a little downward pressure
on the tube will ensure a good seal.
Pump the handle on the bottle to inject water into the boiler whilst
maintaining this downward pressure. Keep pumping until the water
level in the water gauge is almost at the top of the glass.
Remove the plastic tube. Note that a small amount of water will
remain in the top of the valve but will evaporate away as the valve
heats up. Replace the roof.
8
Safety Valve located under Dome.
Remove
Dome to
access Safety
Valve