Page 9 of 17
No.
Description
Qty.
No.
Description
Qty.
13
Pump chamber
1
32
Switch bracket
1
14
Bypass valve
1
33
Nozzle holder
1
15 O-ring 1
34 Auto
Nozzle 1
16 Filter
screen 1
35
Screw
2
17
2" Bung adapter
1
18 Screw 2
19 Suction
tube 1
Assembly Instructions
1.
Tightly screw suction pipe into inlet coupling of pumping unit. Extend suction pipe into truck tank
or barrel to within 3" of tank bottom.
2.
Screw inlet coupling of pump into 2" tank or barrel opening. Inlet coupling must be completely
and securely threaded into an undamaged tank or barrel bung.
3.
During installation and maintenance, make sure that the electric supply lines are not live.
4.
Always turn off the switch before supplying electrical power.
5.
Check the correct rotation direction of the AC pump. If it is inverted, check the polarity of the
connection cable.
a)
BLACK cable: positive pole (+)
b)
WHITE cable: negative pole (-)
6.
Systems should be designed to require a minimum amount of suction lift. Maximum “equivalent
feet of lift” is 8’ for diesel fuel.
7.
Tank or barrel must be properly vented. A water separator should be used for pumping diesel
fuel.
8. AC
Electrical
8.1 Electrical wiring should be done by a licensed electrician in compliance with local, state, and
national codes.
8.2 Remove the pump’s electrical junction box cover and straighten the 3 wires to make the
stripped wire ends accessible outside of the junction box.
8.3 Install rigid conduit and wires from the power source to the junction box to maintain
explosion-proof integrity.
8.4 Connect wires to pump connecting like colored wires together. Ground wire must be
connected.
8.5 Fold wires into junction box and replace cover making sure the gasket is in place. Make sure
all screws are seated so there is no space between the cover and the junction box. The
installation is now complete.
