Rottler SG7MTS, Руководство по эксплуатации и обслуживанию

Страница: 39 / 111

Section 5 Operating Instructions SG7MTS Manual
www.rottlermfg.com
5-7
Three Angle Seat Cutting
Place the ball drive adapter in the spindle. Align spindle to
valve guide.
Place a valve in the setting fixture. Position the pointer on
the valve where you wish to place the top of the seat.
Remove the valve; replace it with the correct pilot.
Select the proper diameter tool holder. Place the carbide
insert in tool holder. Slide tool holder onto ball head.
Place ball head over the pilot in setting fixture. Use radial
adjusting screw to set diameter of cutter to correspond to
position of pointer on setting fixture.
Tighten hex socket screws on bottom of ball head. See
figure 9
Remove ball head assembly from setting fixture. Place
fixed carbide pilot in cylinder head.
Center the spherical ball head tool holder over the pilot
shank.
Required spindle rotation speed will vary, depending on
seat hardness. As seat hardness increases, so does the
required spindle speed. Some will require full speed.
Special care should be taken in centering the floating head
above the valve guide, to achieve a concentric seat.
Cut seat only enough to clean up surface.
Too much cutting will sink the valve too far in the head.
Many operators prefer to use the spindle fine feed when
machining seats as extreme control of spindle down feed
can be accomplished.
The capacity of the Rottler SG80MTS associated with a complete tooling range allow working on seats of
diameters between 14 and 120 millimeters (0.55’’- 4.7’’).
Three tooling ranges are possible:
1) For seats diameters between 14 and 25 mm ( 0.55’’- 1’’): tool holder BH600R1 and Mini tip holder
TH1999 for seat range .551” - .984” (14mm-25mm) with pilots with 6.00mm shank diameter.
2) For seats diameters between 18 and 60 mm ( 0.71’’- 2.4’’): tool holder BH375R1, or UPT5100
(SG10A,9M only) and tip holder TH2000 for seat range .710” - 1.180” (18mm-30mm) or TH2001 for seat
range 1.100” - 1.570” (28mm-42mm) or TH2002 for seat range 1.570” - 2.360” (40mm-60mm), with 9,52
mm ( 3/8 ’’) pilots of shank diameter
3) For seats diameters between 40 and 80 mm (1,570”- 3.150”): tool holder BH375WR1 or UPT5300
(SG10A,9M only) and tip holder TH2003 for seat range . 1.570’’ - 2.360’’ (40mm - 60mm) or TH2004 for
seat range 2.280” - 3.150” (58mm - 80mm), with pilots with 9,52 mm ( 3/8 ’’) shank diameter.
IMPORTANT: When the form tips, the square tips or the triangle inserts are fitted, check that their
reference faces are perfectly clean.