TOOL ONLY COUNTER-CLOCKWISE to
take advantage of the “hugging” action of the
bit along the contours of the template.
Remember to use a smooth, continuous
motion. The exception to this rule applies to
cutting window and door openings. Since you
are tracing around the inside of the framing
members, move the bit clockwise to take
advantage of the bits “hugging” action.
INSERTING AND RELEASING BATTERY PACK
Slide the switch button in to "0" position.
Slide charged battery pack into the housing
until the battery pack locks into position (Fig. 1).
To remove the battery pack,press and hold the
battery pack release button and slide the
batterypack back completely out of tool housing
(Fig. 1).
IMPORTANT CHARGING NOTES
BATTERY CHARGE CONDITION
INDICATOR LIGHTS
Your tool is equipped with charge condition
indicator lights (Fig. 1). The indicator lights
shows the charge condition of the battery.
To check the charge condition, press and hold
the charge condition indicator button with the
tool in the off position.
3 of 3 Solid Green LED’s = 67-100%
2 of 3 Solid Green LED’s = 34-66%
1 of 3 Solid Green LED’s = 16-33%
1 of 3 Flashing Green LED’s = 0-15%
Your tool is equipped with advanced
electronics that protect the Li-Ion cells in the
battery from damage due to excessive
operating temperature and/or current draw. If
the warning symbol illuminates red and/or the
tool stops working during heavy use, this most
likely indicates that the Li-Ion cells are near
their maximum operating temperature, and the
battery pack should either be changed or
allowed to cool to ambient temperature before
continuing use. If the tool automatically turns
off due to overload conditions, the switch must
be turned off for a few seconds to allow the
circuit to reset before continuing use.
1. The charger was designed to fast charge
the battery only when the battery temperature
is between 32˚F (0˚C) and 113˚F (45˚C). If the
battery pack is too hot or too cold, the charger
will not fast charge the battery. (This may
happen if the battery pack is hot from heavy
use). When the battery temperature returns to
between 32˚F (0˚C) and 113˚F (45˚C), the
charger will automatically begin charging.
2. A substantial drop in operating time per
charge may mean that the battery pack is
nearing the end of its life and should be replaced.
3. Remember to unplug charger during storage
period.
4. If battery does not charge properly:
a. Check for voltage at outlet by plugging in
some other electrical device.
b. Check to see if outlet is connected to a
light switch which turns power “off” when lights
are turned off.
c. Check battery pack terminals for dirt.
Clean with cotton swab and alcohol if
necessary.
d. If you still do not get proper charging,
take or send tool, battery pack and charger to
your local Bosch Service Center. See “Tools,
Electric” in the Yellow Pages for names and
addresses.
Note:
Use of chargers or battery packs not
sold by Bosch will void the warranty.
-11-
RZ 2610955692 11-08:RZ 2610955692 11-08 11/10/08 9:24 AM Page 11
