Rothenberger RODRUM L, Инструкция по эксплуатации

Страница: 23 / 212

ENGLISH 17
5.2 Transfer
5.2.1 Height adjustment of the transport handle (B)

Open both locking bolts and lock this through turning through 90°.
During opening, hold the handle in position.

Select the suitable handle height. According to the application there are four selectable han-
dle settings. The lowest handle position is the setting for transport in a vehicle.

Turn both locking bolts back into the locking position.
Ensure that both locking bolts audibly engage; if necessary check through light
shifting.
5.2.2 Loading the pipe cleaning machine (C)

Place the pipe cleaning machine backwards into the loading area of the vehicle.

Select the suitable handle height according to 5.2.1.

Tip the pipe cleaning machine with the transport wheel on the loading area of the vehicle.

Raise the pipe cleaning machine with both hands and push this completely onto the loading
area.
When raising the pipe cleaning. select a back-friendly
operating method, crouch down first before lifting
with both hands or two people lift the pipe cleaning
machine as a pair.

Place the pipe cleaning machine in the vehicle so that this does not slip during the drive.
Never transport the pipe cleaning machine lying down!

Stow away the cable in a manner suitable for transport.
5.3 Commissioning
The pipe cleaning machine should exclusively be operated by instructed and
authorized personnel!

Check the electrical installation at the work place.

Place the foot switch in such a way that it can be easily reached and that all control ele-
ments are easy to operate.

Push the guide tube over the spiral up to the dead stop on the feed unit housing and fix in
place with the catch.

Connect the mains power plug to the appropriate power supply network.
Ensure that the motor switch is set to “OFF“!
Never use the cleaning device without a footswitch and guide hose!
5.4 Coupling/ Decoupling the tools / spirals (A/D)

Remove the tool box from the holding device (see Figure D).

Select the suitable tool for use.
Coupling:

Push the tool / spiral until it engages with the coupling and check for firm seating.
Decoupling:

Push the segregation key into the bore and push the tool / spiral to the side out of the cou-
pling.