WARNING: Do not wear gloves, rings, or loose
clothing while operating the E-Z Cutter. Remove all
burrs from material to be cut.
1. Before making electrical connection, set the E-Z
Cutter for the material you intend to cut:
(a)
Lift the head casting with feed wheel bar
removed from the sprocket.
(b) Feed the material underneath the cutter wheel.
(c) Lower the head casting until the cutter wheel
rests on the material to be cut.
(d) Put the feed wheel bar into the appropriate
sprocket that allows you to pull down
comfortably through the material.
(e) Push feed wheel bar back towards the motor
until it stops against the rest of the head
casting.
2.
Make electrical connection: (Voltage of outlet
must be the same as voltage indicated on the tag
and name plate.) Put twist lock plug into side of
E-Z Cutter, position safety foot switch and plug
into proper outlet.
3. While E-Z Cutter is off, feed material with left
hand to desired cut off location underneath cutter
wheel. Bring cutter wheel down with feed wheel
bar so it rests easily on your cut off mark and apply
slight pressure on the feed wheel bar.
4. Remove left hand from material.
5. Turn machine on with foot switch. Power driven
rollers will rotate pipe.
6. Pull down on feed wheel bar until material is cut.
Do not force the cut, let the machine do the work.
WARNING: Ensure you have the proper support for
the cut material.
7. After material is cut, lift head casting by pushing
back on feed wheel bar while turning off machine.
WARNING: Do not grasp rotating stock.
8. After stock stops rotating, feed again and repeat
process.
Operating Instructions
8
COLLINS E-Z CUTTER
Phone 800-545-7698 • FAX 815-633-0879
www.rothenberger-usa.com
