23
User manual
Split wall air conditioner - UKURA W
PART 6. WIRED CONTROLLER SUPPORT
2. POWER (ON/OFF) button
Pressing „ ”Enables or disables the wired controller. Pressing the power button will turn on the controller,
the indicator lights on the display will light up and the controller will be ready for operation. When pressed
again, the signaling diodes will go out and the controller will turn off.
If the air conditioner is turned on and the TIMER ON or TIMER OFF function has been set and the „ ”Then
the TIMER ON or TIMER OFF function will be canceled by the controller. The TIMER settings do not apply
when the controller is turned off.
3. UP adjustment button
Pressing the „ „Increases the temperature. A long press of the button will increase the temperature
setting by 1°C every 0.5 seconds.
4. DOWN adjustment button
Pressing the „ „Reduces the temperature. A long press of the button will lower the temperature setting
by 1°C every 0.5 seconds.
5. CLOCK setting button
Hold CLOCK for more than 4 seconds and the clock on the display will flash at a frequency of 0.5 seconds.
Using the UP buttons („ „) and DOWN („ „) Set the desired time. Pressing the buttons once will increase/
decrease by 1 minute, holding these buttons will increase/decrease the time value at an accelerated pace.
After the desired time is set, release the CLOCK button to end time editing. The clock will stop flashing.
6. SPEED fan speed button
Press the button to set the unit’s fan speed. Select a fan speed from the four available speeds: AUTO , LOW .
Average and HIGH . Each press of the button will change the fan speed in the following order:
7. TIMER button
Press this button to run the functionTimer. Using the UP buttons („ „) and DOWN („ „) Set the desired
time. The clock will increase/decrease the time value every 10 minutes. Holding the buttons will allow the
TIMER to be set faster by 10 minutes every 0.2 seconds.
8. SWING button
If the indoor unit is equipped with swinging louver, press the SWING button. Pressing the button again will
disable the SWING function.
9. Button to cancel the TIMER setting
Press this button to cancel the TIMER settings.
