72
User manual
Hydrobox module AQMS80X1i
EN
PART 2. INSTALLATION MANUAL
4. INDOOR UNIT INSTALLATION
4.1. Installation Instructions – Indoor unit
CAUTION
The indoor unit should be installed in a water proof place, or the safety of the unit and the operator cannot
be ensured.
Step 1: Select installation location
The indoor unit is to be wall mounted in an indoor location that meets the following requirements:
D
The installation location is frost-free.
D
The space around the unit is adequate for serving.
D
The space around the unit allows for sufficient air circulation.
D
There is a provision for condensate drain and pressure relief valve blow-off.
D
The installation surface is a flat and vertical non-combustible wall, capable of supporting the operation
weight of the unit.
D
There is no danger of fire due to leakage of inflammable gas.
D
The equipment is not intended for use in a potentially explosive atmosphere.
Inspecting, handling and unpacking the unit
The indoor unit is packed in a box.
At delivery, the unit must be checked and any damage must be reported immediately to the carrier claims agent.
Check if all indoor unit accessories are enclosed. Bring the unit as close as possible to the final installation
position in its original package in order to prevent damage during transport.
• The indoor unit weights approximately 60kg and should be lifted by two persons using the two lifting
bars provided.
WARNING
Do not grasp the control box or piping to lift the unit! Two lifting bars are provided to lift the unit.
Step 2: Dimensions and service space (mm)
• Dimensions of the wall bracket
