Communicator | 3.05
40
10.2 Event Codes
Table 1 lists the event codes sent in text messages.
Table 3: Event Codes
Event Code
LCD Message
1
"power off "
2
"power on"
3
"cold start"
4
"error-01"
5
"test running"
6, 7 , 9, 10, 11, 12, 16, 17
"fail"
8, 13
"no answer "
14
"page sent "
18
"text sent "
19, 20
"ack alarm "
21
"disable alarm "
22, 23, 24
"low signal"
10.3 Advanced Alarm Settings
The following sections detail the advanced alarm functions. Basic alarms are set up in the Initial
Configuration.
•
•
•
Defining the Message Delay, page 41
•
Defining the Message Repeat Parameter, page 41
•
Defining the Internal Alarms, page 42
•
Defining the Internal Alarms, page 42
•
Defining the Battery Alarm, page 42
10.3.1
Resetting the Alarms
•
Go to
ALARM > Reset
.
This menu resets the alarms of any controller that exists within the network. The Communicator’s unit
number is
0
.
Use the
+/-
key to navigate to the required unit number.
SELECT UNIT (+/- KEY)
TO RESET PRESS ENTER
UNIT =
↵
