Rotem communicator, Руководство пользователя

Страница: 48 / 84

Page 47 of 82 Revision No.: 1.5
11) Installation
1. Plug in the Communicator to a power source.
2. Go to 'Hardware Profile' selection, by choosing menu 9.1 in the main
menu (see Fig. 3 ). Fig. 83 results this choice. Make sure all the
components are recognized by the Communicator
.
Fig. 83: Hardware Profile menu screenshot
3. Go to 'Battery Test' option, by selecting menu 9.3 (see Fig. 3 ). Fig. 84
results this selection. Check the battery recognition and charging; as
long as the communicator unit is plugged in, the charger inactive note
will be displayed.
Fig. 84: Battery Test selection screenshot
4. Fig. 85 presents the functional block diagram of the controller.
5. Connect controllers according to the photos below; If RF
communication is used connect the controllers according to
Fig. 86-87 .
6. Install the communication software from the attached CD (for
installation instructions, please refer to
Appendix D ).
7. In order to install the external connection box, refer to Fig. 88 .
Attention!
•
Do not keep the battery connected without electricity.
•
Use an exclusive phone line for the Communicator. (Do not share a
line for the Communicator with another phone)

Note: Sometimes using a phone line via private switchboard might
cause problems, therefore it is recommended to use a different line to
the communicator.