28
4. Programming
The following function buttons under the display (1) are
used for programming:
P
Program mode
>
Selection button
ok
Confirmation button
exit
Stop or exit the programming
☛
It is possible to reprogram the following settings:
Filter / Water hardness / Temperature / Language / Time (Standby time on or off)
4.1 Filter
Filter use
You receive a special filter as an accessory for the water tank of this coffee machine.
By using the filter correctly, it is no longer necessary to de-calcify your coffee machine.
The filter setting must be set to
YES
so that the machine recognizes that the filter is in
use. The factory setting is without a filter.
☛
If you use a filter in your coffee machine and have programmed the system fil-
ter setting to
YES
, programming for water hardness and decalcifying will not be
shown anymore.
• Press the programming button
P
in order to start program mode.
• Press the
>
button until the display shows
FILTER
.
• Press the
ok
button.
• Press the
>
button until the display shows
YES
.
• Confirm with the
ok
button.
• The display will now show
CHANGE FILTER / TURN valve
alternatingly.
• Empty the water tank (17) screw the filter into the holder (21) using the mounting
tool (24).
• Fill the tank with freshwater and replace it in the machine.
• Hold a receptacle under the hot water jet (12) and turn the dial (11) to the right. The
system will now be rinsed.
• Wait until no more water comes out of the jet and then turn the dial (11) closed to
the left.
• The system will heat up briefly and is then ready for operation again.
(It can happen that the service button [7] is still blinking. Press the button [7] and a
short rinse will take place through the coffee outlet [8].)
☛
The effectiveness of the filter is exhausted after about 50 l of water. The display
will indicate that the filter must be changed (see chapter 5.2).
Important:
Even if the display shows nothing, the filter should be changed after
two months at the latest even if little coffee was brewed.
