R1 8” Tower Speaker Installation Instr
u
ctions
www.roswellmarine.com
5
H
Install the 5/8”-11 clamp set screws with red thread
lock to secure the clamps into place.
Note: This set screw will leave a mark
on your tower
when it is tightened.
x2
2-1/2”
5/8”-11 x
13/16”
THREADLOCKER
5/16”
RED
THREADLOCKER
5/16”
RED
Double check mounting position is correct before completing this step
Use & Care
These speakers are built to the highest standards of marine durability. However, they are still a sensitive piece of electronic
equipment. When cleaning, avoid hosing down the speakers directly and do not use harsh cleaners on the R1’s as they could
damage the finish. Simply wiping the speaker down with a damp cloth should be sufficient to ensure years of enjoyment.
It is necessary to regularly check the tightness of the bolts securing the R1 speaker to your tower. Bolts and screws tend to
rattle loose over time due to the vibrations and shaking that your boat experiences while on the water or in transit.
Covering your speakers with something removable like saran wrap or aftermarket fabric covers during transit or storage can
save you a lot of time cleaning and also protect your speakers from damage.
G
Rotated mounting
Square mounting
Determine your mounting angle for the speaker. If you are not mounting the speaker
perpendicular to the tower tubing: Remove the 4 set screws using a ball end allen key
rotate the speaker to the desired angle (this may require some force, so be careful), apply
red thread lock to the set screws and re-install the set screws.
Set angle then tighten
Set angle then tighten
