www.roswellmarine.com
3
PACKAGE CONTENTS
TOO
L
S & SUPPLIES NEEDED
3/16” Allen Key
5/16” Allen Key
Port
Speakers
Starboard
Speakers
(x2)
Wiring
Harness
x8
x2 x2
x4
Heat Gun
Utility
Knife
THREADLOCKER
RED
Wire Strippers
& Crimps
x4
1.90” Clamp Insert
x4
2.375” Clamp Insert
x4
3.00” Clamp Insert
Preparation
Tower and boat Wiring
(not included)
• For safety, turn off the audio system and battery switch prior to beginning installation. If your vessel does not have a battery switch,
simply disconnect the positive lead from the battery terminal and wrap the end of the wire in electrical tape.
• Use extreme caution before cutting and drilling holes to avoid damaging fuel lines, hydraulic lines, or existing electrical
components. Avoid running wires near sharp edged surfaces. Never run wires exposed on the deck, protecting the wires with a
cover offers the best protection from marine elements. If wires must be routed through metal or fiberglass walls, use rubber
grommets to protect the wire.
• Roswell recommends using 16 gauge wire for the audio connections and 18 gauge wire for the 12-volt LED connections.
• You will need to supply a length of positive and negative 16 gauge speaker wire to run from your speaker mounting locations to
your amp or head unit. Connections to either an amp or head unit are your responsibility to provide. If wiring to a head unit, be
sure that the head unit is 2 ohm stable.
Positioning
• We suggest mounting your speakers on the rear crossbar of your tower facing backwards. Many people position them further to
the sides of the tower to have more headroom when moving around inside the boat. Make sure you have enough clearance around
the rotating speaker so that it won’t come into contact with anything throughout its 180 degrees of travel.
Wire Routing
• Consider how you will route your wires before you begin your installation. Because each boat and tower setup is different, there are
no specific instructions for wiring the tower – generally most people will run the wires internally through their tower. Alternatively,
some people choose to run their wires outside the tower using zip ties or another attachment system. The choice is yours.
• All wiring should be done by a qualified marine technician.
Tubing Size
• These speakers include three different inserts for the tubing clamp: 3.00”, 2.375” and 1.90”. If your tower requires a clamp insert not
provided please contact Roswell at 1 (321)-638-1331 for optional inserts. Alternative sizes available are: 2.85”, 2.50“ and 2.25”
WARNING
• These speakers are capable of easily producing sound pressure levels (SPL) in excess of 100 dB, even in an open-air environment
like a boat. Sound pressures at or above these levels can easily cause permanent hearing damage or loss. Be sure to use safe
listening practices and protect your ears.
• Roswell recommends audio components be professionally tuned for optimal performance and lifespan. Improper tuning can
damage speakers and IS NOT covered by warranty. A professional audio installer can make your system more ecient, durable and
provide a better sounding system.
x2
x2
(x2)
Safety
Lanyard
6.5x5.25” Classic Vamp Spin Speaker Installation Instr
u
ctions
Measuring
Tape
Phillips Screw
Driver
Torque
Wrench
5/8-11 x 0.50”
5/8-11 x 1.00”
3/8-16 x 0.625”
16A
WG Butt C
onnec
tor
#6 tapping x 0.75”
#6 w
asher
