Rossum Electro-Music MOB OF EMUS, Руководство по эксплуатации

Страница: 17 / 42

| 17
Bank 3
Rhythm Patterns and Filtered Noise
The rhythm patterns are 16 step micro-
sequences that can be useful in setting up a
basic drum/rhythm pattern. In the diagram
below, each step represents 1/16th of the
frequency period of the channel. For the
purpose of these patterns, it may be useful
to think of one frequency period as 4 quarter
notes, with each step representing a 16th
note.
NOTE:
The two gates in Kick 0 are
stretched to 8th notes.
The Filtered Noise output is a white noise
source followed by a tunable low pass
filter. The low pass filter cutoff frequency is
determined as a function of the channel’s
frequency. Useful both as an audio source
and a modulation source, the noise color
will be white with a channel’s frequency
(and octave) cranked all the way up, red/
brown at low frequencies, and various shades
of mauve in between. Again, stacking can
produce interesting results.
PHASE/SYNC/1S
This control allows you set a
channel’s phase offset, from
0-360 degrees, to enable hard
sync with Channel 1 as the
master, and set a channel to
1-Shot mode.
A NOTE:
When setting Phase, there are
small dead zones at 90 degrees, 180
degrees, and 270 degrees to make it easy to
set up quadrature LFOs.
IMPORTANT NOTE:
Options 1 & 2 are
essentially two-position switches. In each
case, rotating the knob counterclockwise from
12 o’clock turns the function off, while turning
it clockwise from 12 o’clock turns it on. The
specific position doesn’t matter, as long as it’s
either to the right or left of 12 o’clock.
In 1-shot mode, upon being triggered, the
wave will play once and stop until triggered
again. Cyclical waves will play for one cycle.
Filtered Noise and Smoothed Random
Voltage will play for one frequency period.
NOTE:
When Filtered Noise in is 1-Shot
Mode, the Phase control will set the
delay until onset. When Sample & Hold and
Smoothed Random Voltage is in 1-Shot Mode,
Phase will control the delay until update.
In Individual Mode:
Primary: Sets a channel’s phase offset, from
0-360 degrees.
Option 1: Enables hard sync, with Channel 1
as the master.
Option 2: Sets a channel to 1-Shot mode.
In Hex Mode:
Primary: Offsets all channels’ phase settings.
Option 1: Enables hard sync for Channels
2–6 with Channel 1 as the master.
Option 2: Sets all channels to 1-shot mode.
1 KICK 0
2 KICK 1
3 KICK 2
4 BACK BEAT
5 HIHAT
6 CLAVE 1
7 CLAVE 2
8 PHUN
9 FILTERED
NOISE