22
T e c h n o l o g y f o r c l e a n p o n d s
4.2.3 Installation and application preparation
Mounting the brush head on the telescopic rod:
Telescopic rods BISAM1021 and BISAM1024:
•
First, direct your attention to the spiral cable fixed to the end of the rod with Velcro (step 1) . Do not let go of this cable
under any circumstances when releasing the Velcro, but immediately screw the plug connection to the brush plug (step
2 and step 3) .
•
After connecting the cables, push the adapter of the BISAM 44 BRUSH along with the cable into the telescopic pole (step
4) and fix it with the wing screws (step 5) .
•
Keep the Velcro tape and, in case of disassembly, fix the cable to the telescopic rod again as before installation .
Notice!
If the cable retaining strap is loosened before connecting the plugs and the plug located on the telescopic rod is not
held, the cable may slip back into the telescopic pole . If the cable has slipped back into the rod, you can get it out again by
shaking the rod downwards . Alternatively, you can "fish" for the cable with a bent wire and pull it out .
Telescopic rod BISAM1025:
•
With this telescopic rod, the cable does not run inside but outside due to its length .
•
Screw the plug connection to the brush plug (step 2 and step 3) .
•
To improve the operability of the telescopic rod, wrap the cable 3-4 times around the telescopic rod . This prevents the
cable from hanging loosely from the telescopic rod .
Mounting the battery with the switch unit and the telescopic rod when using
the battery option:
•
First check that the switch unit is in the centre position '0' for off .
•
Now insert the battery (1 .1) into the battery holder (1 .2) attached to the belt
adapter (1 .3) .
•
In the third step, connect the battery (1 .1) to the switch unit (1 .4) by screwing
both plug connections together . Use the short cable of the switch unit .
•
Then connect the telescopic rod (1 .5) to the switch unit (1 .4) by screwing both
plug connections together . Use the long spiral cable of the switch unit .
Notice!
Make sure that the plug connections are plugged in exactly and secured
with the lock nut . Please do not hold or turn the plugs at the outer blue ends .
Mounting the power supply unit with the switch unit and the telescopic rod
when using the power supply option:
•
First check that the switch unit is in the centre position '0' for off .
•
Now connect the power supply unit (2 .1) with the extension cable (2 .2) by
screwing both plug connections together .
•
In the third step, connect the extension cable to the switch unit (2 .3) by screwing
both plug connections together . Use the short cable of the switch unit .
•
Then connect the telescopic rod (2 .4) to the switch unit (2 .3) by screwing both
plug connections together . Use the long spiral cable of the switch unit .
Notice!
Make sure that the plug connections are plugged in exactly and secured
with the lock nut . Please do not hold or turn the plugs at the outer blue ends .
1 .1
1 .4
1 .5
1 .2
1 .3
2 .1
2 .3
2 .4
2 .2
Step 1
Step 2
Step 3
Step 4
Step 5