Controller Functionality
66
AYC-E/Q/T60 Family Installation and Programming Manual
6.10.17
PIN Code Length/Factory Default Settings
You must be very careful before using this command!
Changing the PIN code length also erases the entire memory
contents, including all user and special codes, and returns all
codes to their factory-default settings.
To change the PIN code length:
1.
Enter Programming mode.
2.
Select the desired PIN code length as follows:
00
– Returns to factory defaults and sets a 4-digit code
05
– Returns to factory defaults and sets a 5-digit code
06
– Returns to factory defaults and sets a 6-digit code
08
– Returns to factory defaults and sets a 4-8 digit code
When choosing the 4-8 option, please note that you should
either enter zeros before the code, or press pound at the end
(for example if your code is 12345, enter either
00012345
or
12345#
).
Both the Mode and Door LEDs
flash red.
3.
Enter your Programming code.
If the Programming code is valid, all memory is erased. You hear
three beeps and the controller returns to Normal mode.
If the Programming code is invalid, you hear a long beep and the
controller returns to Normal mode without erasing the memory
contents.
Mode/Transmit
Door/Program
Green
Mode/Transmit
Door/Program
Red
Red