Wiring Instructions
AYC-E/Q/T60 Family Installation and Programming Manual
17
4.
Wiring Instructions
The unit is supplied with 56-cm (22”) pigtail, having a 6-conductor
cable.
To connect the unit to the controller:
1.
Prepare the unit's cable by cutting the cable jacket back 3.2 cm
(1¼”) and stripping the wire 1.3 cm (½”).
2.
Splice the unit’s pigtail wires to the corresponding controller wires
and cover each connection.
Refer to Table 1 and to the wiring diagrams provided on the following
pages.
Table 1: Wiring Colors
Reader
Controller
Color
Functionality
5~16 VDC
5~16 VDC
Red
+DC Input
Shield/Ground
Shield/Ground
Black
Ground
Data 1/Clock
C 1
White
Communication
Data 0/Data
C 2
Green
Communication
G.LED/LEDCTL
AUX. IN
Brown
LED Control/Auxiliary Input
Tamper
Tamper
Purple
Tamper
3.
If the tamper output is used, connect the purple wire to the
correct input on the controller when used as a reader, or to a
zone input of an intruder alarm system when used as a controller.
4.
Trim and cover all unused conductors.
•
The individual wires from the unit are color-coded according the
Wiegand standard.
•
When using a separate Power Supply for the Reader, this Power
Supply and that of the Controller must have a common ground.
•
The Reader’s cable shield wire should preferably be attached to an
earth ground, or a signal ground connection at the panel, or power
supply end of the cable. This configuration is best for shielding the
Reader cable from external interference