User Manual
UNLOCKING FOR MANUAL OPENING
Turn and turn the key clockwise
and pull the lever up to 120°.
1
2
Pull the lever.
3
Leave at 120°
120°
a
Put and rotate
key in clockwise
directio
n
SIA30 FS
INSTALATION
Active Infrared Sensor
- The gate barrier sensor SIA30 must be installed with a max. distance between the Transmitter and the Receiver.
- It must be at the same height and in the same alignment (when aligned the led indicator of the receiver goes out), ideal height for installation in gates is
50cm.Fig 01
- Installation should be done as close as possible to the gate.
NOTES ON INSTALLATION
• Do not set near plants and objects that could interrupt the beam of SIA30
• The transmitter and receiver can not be installed on mobile, unstable bases or in places that move easily.
• Always leave lenses clean
• Do not install the receiver with the lens facing the sun.
FEATURES
• Transmitter
- Power Supply 12Vcc
- Consumption 30mA
• Receiver
- Power Supply 12Vcc
- Consumption 25mA
• Maximum distance
- 30m
•
Easy alignment
• Box with solar filter
• Drive indicative LED on RX
• Works in NA or NF mode
• Contacts NF - NA Maximum current 1A
Rx
Tx
Easy alignment
Max. 30m
0.50m
Tx
Page 4
DIGITAL ACCESS KEY CONFIGURATION HCS (Rolling Code)
To add the digital key code to the control panel, press and release the "LEARN"
button on the control panel or the Rossi receiver and immediately press one of
the key's buttons. To record other buttons, repeat the operation.
Note:
buttons 1 and 2 of the key are independent.
Erase memory
- If you want to erase all the codes of the keys recorded on the
control panel, press the "LEARN" button and keep pressed until the "ST" LED
goes out.
Digital access key
Command Center
R
X
drilling
measures
