Ross SYNERGY 4000DR-003, Руководство по эксплуатации, Страница: 184 / 332

7–10 • Keying Synergy Series Operation Guide (v18)
before taking a key to air, and also when you want to quickly identify which key is
which on an MLE, when both keys are on-air simultaneously.
• (MLE Key 1 group only) Press
KEY OVER
to change the priority of the two
keyers with a cut . Normally, Key 2 is over (visually on top of) Key 1 . However,
when
KEY OVER
is lit, Key 1 is over Key 2 .
• (MLE Key 2 group only) Press
CHAR GEN
to select your most frequently used
“favorite” character generator, without having to hunt for it on the Key Bus . When
pressed, the key type and key source are automatically selected,
KEY MEM
is
turned on, and key modifiers are turned off to provide a clean CG key. Refer to the
section “ Programming a Favorite CG ” on page 7–62 for instructions.
• (All groups) The
ON
LED has three states:
~ When the LED is
Off
, the keyer is turned off and not contributing to the output
of the MLE or switcher.
~ When the LED is lit
Green
, the keyer is turned on but contributing to the
output of the MLE only — not the program output of the entire switcher.
~ When the LED is lit
Red
, the keyer is turned on and contributing to the
program output of the entire switcher.
Note that the state of the
ON
LED is duplicated by the associated keyer’s
ACTIVE
LED in the MLE’s Transition Group (directly under the
KEY 1
or
KEY 2
“next
transition” button).
• (DSK groups only) The
N/S
LED, when lit, indicates that the selected key alpha or
fill signal is non-synchronous.
5. Key Transition Section (All groups)
The buttons in the Key Transition Section provide you with two methods for taking the
selected key on or off air:
• Press CUT to instantaneously “cut” the key on or off air.
~ If the key is currently off, press
CUT
to cut the key on.
~ If the key is on, press
CUT
to cut it off air.
The
CUT
button itself is momentary — it does not stay lit. Refer to the section
“ Key Cut Notes ” on page 7–47 for additional important rules regarding the
CUT
button.
• Press
AUTO TRANS
to smoothly transition the key on or off air, using a dissolve
(from 1 to 999 frames).
~
If the key is currently off, press
AUTO TRANS
to dissolve the key on.
~ If the key is on, press
AUTO TRANS
to dissolve the key off air.
The
AUTO TRANS
button is momentary — it stays lit only during the transition.
Refer to the section “ Using Auto Transitions ” on page 7–45 for more information
on changing auto transition dissolve rates.
Operating
Tip
You can also change the priority of the two keyers in the Key Setup
Menus by toggling the Key Over softkey between On and Off . Refer
to the section “ Using Keys ” on page 7–20 for more information.
KEY
OVER
CHAR
GEN
ON
N/S
CUT
AUTO
TRANS