Ross SYNERGY 4000DR-003, Руководство по эксплуатации, Страница: 236 / 332

7–62 • Keying Synergy Series Operation Guide (v18)
9. If a border (
BORD
) is selected, press the
Ghost On/Off
softkey to remove the key fill.
10. Adjust border color using the controls in the Mattes group.
• When
BORD
in Key 1 or DSK 1 is selected,
BORD 1
is automatically selected in
the Mattes group.
• When
BORD
in Key 2 or DSK 2 is selected,
BORD 2
is automatically selected in
the Mattes group.
You can also create a wash as the border color. Refer to the section “ Creating Washes ”
on page 6–19 for instructions.
This completes the procedure to border a key.
Notes on the Fly Border Function
Note the following important points regarding the Fly Border function:
• All types of keys can be bordered, however, note that some preset patterns keys may
exhibit a
repeated border if the border is positioned too far away from the key source.
• Be sure to press the
CENTER
button (in the Positioner group) before adjusting your
borders initially. This action resets all parameters to their default values.
• All border settings can be stored to and recalled from a storage device, such as a floppy
disk or USB key. In addition, the borders are
copied when using the MLE Copy and
Key Copy functions.
• If a border is positioned below the key source, it reacts within the same field as the
moving video. If the border is positioned above the key, it reacts one field later than the
moving video.
• Use the controls in the Positioner Group to move two borders simultaneously. Simply
press
BORD 1
and
BORD 2
simultaneously, and use the Positioner in the normal way.
Programming a Favorite CG
This procedure allows you to select a “favorite” CG that you want to place on the CHAR GEN button
in each MLE’s Key 2 Group . The feature is designed so that you can quickly select a “clean” CG in
the Auto Select mode, with no key modifiers enabled. (Note that there is no CHAR GEN button in
the DSKs.)
Use the following procedure to program the “favorite” CG button:
1. Press and hold the CHAR GEN button in any MLE’s keyer.
2. On the selected MLE’s Key Bus , press the button for your most frequently used CG.
3. Release both buttons. The selected CG is now stored in memory, and will be recalled
each time CHAR GEN is pressed — in any MLE.
This completes the procedure to program the “favorite” CG button.
Note It is no longer possible to perform the “Ghost” function on a Chroma
Key.
Note You must have the USB Removable Media Drive option installed in
order to save border settings to a USB key.