Ross SRA-8901 Series, Руководство пользователя

Страница: 22 / 40

3–2 • Configuration SRA-8901 Series User Manual (Iss. 02)
Card Overview
This section describes major components of the card hardware. There are no card-edge controls
as all configuration and setup is done using the menus in DashBoard. Refer to the section
“
Monitoring Features ” on page 3-3 for details on the card-edge LEDs.
Figure 3.1 Card Components — Example of a SRA-8901-4
Bootload Button
This button is used for factory service in the unlikely event of a complete card failure. Do not use
this button unless advised by Ross Technical Support.
Bullet Connectors
The bullet connectors on the card-edge insert into the backplane of the rear module, to connect
the card to the rear module. It is strongly recommended to verify that the bullet connectors are
aligned correctly before inserting into the rear module.
Daughter Card
A daughter card may be installed on the SRA-8901 main PCB. This daughter card provides
additional output connections for the rear module.
For More Information on...
• the cabling designations for your card, refer to the section “ Cabling ” on page 2-5.
• the Bootload process, refer to the section “ Bootload Button ” on page 6-2.
Note
— Only the SRA-8901-10 is installed with a daughter card to supply the additional
outputs.
Bootload Button Bullet Connectors