Ross SEA-8203A, Руководство пользователя

Страница: 19 / 36

SEA-8203A User Manual (Iss. 01) User Controls
•
3-3
JP3 — Bypass EQ Mode
The position of JP3 determines the equalizer behavior when the reclocker is set to Bypass .
Note The JP3 setting is used only when JP1 is set to LOCAL .
Select one of the following options:
•
EQ — The equalizer is always enabled and the input signal is equalized.
•
NO EQ — The equalizer is disabled when the Reclocker Rate is set to Bypass .
This setting allows the SEA-8203A to pass signals that are outside the response band
of the equalizer, such as <143MHz. This is useful for very low data rates such as
DVB-ASI.
JP4 — Rate Select
The position of JP4 determines the rate of the SEA-8203A.
Note The JP4 setting is used only when JP1 is set to LOCAL .
Select one of the following options:
•
HD — Sets the cable driver to HD Edge rates.
•
SD — Sets the cable driver to SD Edge rates.
LEDs
This section describes the SEA-8203A LEDs and conditions. Refer to Figure 7 for the location of
each LED.
Figure 7. LED Locations