Ross RSA-7806, Руководство пользователя

Страница: 19 / 32

Connector Wiring for Inputs and Outputs
On the rear of the Ross frame there are removable connectors for two inputs and eight outputs. Unused
outputs do not need to be terminated. See Figure 6 below and the manual for the frame in which you
have installed the RSA-7806 for further details on cable connections.
Each connector has sockets for the positive, negative, and grounded wires of a balanced analog audio
cable. Wire the external cables to the removable terminal block connectors as outlined in the figures
and procedure below.
Figure 6. Connector Wiring for RSA-7806 Inputs and Outputs
Use the following steps to wire the external cables to the removable terminal block connectors:
1. Insert a wire into the designated polarity slot on the connector.
2. Use a tweaker screwdriver to tighten the corresponding screw on the underside of
the connector.
3. Repeat steps 1 and 2 for each wire on each connector.
4. Secure the cable to the connector with a tie wrap.
5. Once the cables have been wired to the connectors, install the connectors to the
sockets on the RossGear frame so that the slotted tongue fits in the grooves on the
frame’s mating connector.
RSA-7806 User Manual (Iss. 02) Installation and Setup
•
2-7