• CLEAN work area Accidents occur where benches and work areas are cluttered or dirty,
floors must be kept clear.
• Make sure only use correct staplers as specified for your tool.(See Fastener specification)
15 Deg. coil nailer nailer for construction framing, pallet and crate assembly, deck construc-
tion, roof decks, fencing, sidewall sheathing and etc.
OPERATING INSTRUCTION
Description
WARNING!:
Never free-fire the tool at high pressure
• Use clean, Dry and Regulated compressed air at 5-7.5bar (70-110psi)
• Never exceed maximum and minimum pressure. Too low or too high pressure would cause
noise, fast-worn or misfiring.
• When connecting air supply always keep hands and body from discharge area of tool.
• A filter-regulator-lubrication is required and should be located as close to tool as possible.
(see below)
• Keep air filter clean. A dirty filter will reduce the air pressure to the tool causing a reduction
in power and efficiency.
• Be sure all connections in air supply system are sealed to prevent air loss.
WARNING!:
Always disconnect the tool from the compressed air before loading.
When loading the tool always point the tool away from yourself and others. Make
sure that you are not holding the tool with trigger depressed while loading the
tool.
Loading fastener and operation
• Disconnect the tool from the air supply Grasp the nailer firmly with one hand .Press the
latch with your thumb and pull the magazine back. Insert a strip of fasteners into maga-
zine Keeping it point down.
• Release the latch and pusher, slid the pusher against the nails until it contacts the nails and
lock into place. The tool is now ready for use.
• Connect the tool to the air supply. Make sure the air pressure is in the correct range de-
noted in the Technical Data.
GENERAL SAFETY Cont .....
Содержание RANCN65
Страница 7: ...EXPLORED VIEW...
