Ross RAAC2.5/36, Инструкция по установке, использованию и техническому обслуживанию

Страница: 4 / 12

RAAC2/24 and RAAC2.5/36
4
Secure the Work Piece
Wherever possible secure the work piece using clamps or a vice. It is safer than using your hand
and leaves both hands free to control the air tool.
Do Not Over-reach
Do not over-reach, keep proper footing and maintain your balance at all times.
Maintain Tools with Care
Keep cutting tools sharp and clean for better and safer performance. Follow the instructions for
lubricating and changing accessories. Check the tool power cord periodically and if damaged
have it replaced by an authorised service facility. Keep handles dry, clean and free from oil and
grease. Ensure that ventilation slots are kept clean and free from dust at all times. Blocked venti-
lation slots can cause overheating and damage to the motor.
Stay Alert
Watch what you are doing, use common sense, and do not operate the air tool when you are
tired or have taken medication that causes drowsiness, consumed alcohol or drugs.
FOR ADDITIONAL PROTECTION FROM ELECTRIC SHOCK
It is recommended that this tool be used in conjunction with a residual current device (RCD)
with a rated residual current of 30mA or less.
General Warnings for compressors
•
Do not attempt to modify the compressor in any way.
•
The use of any tools or accessory other than those designed for use with compressed air
could result in injury to the operator.
•
The output pressure of the compressor should be adjusted to the design pressure of the
air tool or accessory being used.
•
Always check that the output of the compressor does not exceed the maximum pressure
for any attached tool or accessory.
•
Repairs should only be carried out by qualified persons using original spare parts. Fail-
ure to do so may result in considerable danger to the user.
Breathable Air Warning
This compressor/pump is not equipped and should not be used to supply breathing quality air
for any application of air for human consumption.
Overload protection . This compressor is fitted with an overload protection device. In the event
that the motor becomes too hot, a thermal protection device will cut the mains supply to the mo-
tor. When the motor temperature returns to normal the mains supply will be restored automati-
cally.