4–2 • Configuration
GPI-100 User Manual (Iss. 06)
General Settings
This section provides a summary of the initial tasks you may wish to perform before configuring
your card for monitoring VANC data. Before proceeding to any of the other sections, please
ensure that these settings are correct, as they will have an effect on the operation of the other
functions.
To configure the general settings
1.
Select the
Settings
tab.
2.
Type a unique name for your card in the
Card ID
field. This is especially useful if you
have more than one GPI-100 in a frame. You may also want to add “Encode” or
“Decode” to the name. If this field is blank, the name is just “GPI-100”.
3.
Use the
Card Function
to determine if the card will be used to encode (
Encode
)
triggers into the VANC or decode (
Decode
) triggers from the VANC.
4.
Use the
Originator
field to specify a unique value to represent the code that protects
against GPIOs from other originators being detected.
5.
Use the
DID
and
SDID
fields to specify the VANC address used to encoded and decode
the triggers. The default address is 84/2 decimal (54/02 hex). This should not be changed
unless it conflicts with existing VANC data. If you need to change it, please set the same
address in encoders and decoders.
6.
If you selected
Encode
in step 3., set
Encode Line
and the
Encode Channel
values.
These settings are ignored for the Decode Card Function and the card will look for the
triggers on any valid line and channel combination.
7.
Click
Accept
to apply the changes.
8.
You can save the
Configuration
of the card to a file on a PC by clicking
Save
.
9.
The Factory Defaults
Reset
button clears all configuration settings and restores the
settings to as they were shipped from the factory.
Содержание openGear GPI-100
Страница 1: ...GPI 100 VANC to GPIO Trigger Inserter Decoder User Manual...
Страница 6: ......
Страница 8: ...ii Contents GPI 100 User Manual Iss 06...
Страница 14: ...1 6 Introduction GPI 100 User Manual Iss 06...