DEA-8205 User Manual (Iss. 06)
Installation • 2–3
Installing the DEA-8205
This section outlines how to install a Rear Module in a DFR-8300 series frame. The procedure for
installing the Rear Module in your openGear frame is the same regardless of the frame or module
used. However, a different module is required depending on the openGear frame you are using.
Rear Module for the DEA-8205
The following rear modules are required when installing the DEA-8205:
•
DFR-8310 series frames
— Use the
8310AR-030
Rear Module (R1-8205).
•
DFR-8321 series frames
— Use the
8320AR-030
Rear Module (R2-8205).
Installing a Rear Module
If the rear module is already installed, or if you are installing the DEA-8205 in a DFR-8310-BNC
frame, skip this section.
Use the following procedure to install the Rear Module in a DFR-8300 series frame:
1.
Refer to the
DFR-8300 Series User Manual
to ensure that the frame is properly
installed according to instructions.
2.
On the rear of the frame, locate the card frame slot.
3.
As shown in
Figure 2.1
, seat the bottom of the Rear Module in the seating slot at the
base of the frame’s back plane.
Figure 2.1
Rear Module Installation (DEA-8205 not shown)
4.
Align the top hole of the Rear Module with the screw hole on the top edge of the frame
back plane.
5.
Using a Phillips screwdriver and the supplied screw, fasten the Rear Module to the frame
back plane. Do not over tighten.
This completes the procedure for installing the RM-8300-B in a DFR-8310 digital distribution
frame.
