11 • Setup and Operation (Iss. 02)
Setup and Operation
Power Adapter and Supply
Connect the PS-9000 power adaptor to the power supply connector. The
PS-9000 provides up to 2A of reg5V DC (5%). The DC power cord has
a locking connector that securely fastens into the power supply DC jack on the
ADA-9503. The ADA-9503 has a standard miniature power jack (center pin
positive).
If using an adaptor other than the PS-9000, ensure that:
•
the polarity is correct
•
the voltage is +5V DC regulated to 5%
•
sufficient current for the ADA-9503 is supplied
Caution
— Use of improper adaptors may damage the ADA-9503
and will void the warranty.
Installations outside of North America using line voltages of 200-240V require a
plug, certified for the country of use, to be installed on the supplied line cord.
Refer to the section “
Important Regulatory and Safety Notices to Service
” at the front of this manual for details.
Cable Connections Overview
Connect the cables to the ADA-9503 according to the designations indicated on
the chassis label and
. The input is internally terminated at 75ohm. It is
not necessary to terminate unused outputs.
Figure 5
ADA-9503 Connections
POWER
SUPPLY
AES IN
AES OUT 2
AES OUT 4
AES OUT 6
AES OUT 1
AES OUT 3
AES OUT 5
